Reconyx Hyperfire Manuel d'instructions télécharger pdf (Page 15)

www.reconyx.com 14

Level 1: Main Menu Items

NOTE: Main Menu Items are shown in Yellow on the Programming Diagram

(Page 13).

Arm Camera – When you select this option, your camera arms in ten seconds,

unless you cancel it before the countdown is complete by pressing the “OK”

button.

WalkTest – When you select this option, your camera flashes an indicator light

so that you can test its aim by walking in front of it. The WalkTest mode shows

you exactly where the camera’s active motion detection zones are located. The

tilt of the camera is critical, as slight changes are magnified at greater distances

from the camera.

TIP: If left in WalkTest mode, the camera will automatically arm itself after 2

minutes with no motion events. This allows you to set the camera up,

check its aim using WalkTest, and then just walk away.

Erase Card – When you select this option, your camera wipes your entire

memory card clean, removing all images and other information from the card.

You should not select Erase Card unless you are absolutely certain you want to

remove everything from the card.

Check Status – When you select this option, your camera displays the number

of pictures it has taken, the amount of space used on your memory card, and the

amount of battery power remaining.

NOTE: The battery status shows the level for different types of batteries. If you

change battery types be sure to change the “Battery Type” setting.

Change Setup – Allows you to change the way your camera functions.

Battery Type – Allows you to select what type of batteries you are using to

accurately display the amount of power remaining.

Camera Info – The camera will display its firmware version number (V) and

serial number (S). You may need this information when contacting RECONYX™

with questions about your camera.

NOTE: Professional Series cameras have many additional settings that can be

programmed using the Configuration Software on your PC, included with

MapView™ Professional Software (see additional notes below).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Pas de commentaire

Reconyx Hyperfire Manuel d'instructions Page 15