Reconyx Hyperfire Manuel d'instructions télécharger pdf (Page 7)

www.reconyx.com 6

Batteries & Memory Cards

Accessing Batteries, Memory Card & Camera Controls

To install the batteries and memory card, your HyperFire™ camera is easily

opened using the latch on the right side of the camera. Grasp behind the latch

and flip it toward the front. The camera will open like a book, allowing access to

the batteries, memory card and settings.

Step 1

Step 2

Step 3

Breathable Vent

There is a breathable vent underneath the latch of the camera, which will allow

the air pressure inside the camera case to equalize while keeping water out.

NOTE: The breathable vent is vital to keeping the camera weatherproof and

should NOT be removed or tampered with.

TIP: Each time you open your camera it’s a good practice to:

 Make sure the main gasket is seated properly and is clear of debris.

 Check that the breathable vent underneath the latch has not been

damaged.

 Be sure that the windows on the front of your camera are clean.

 Also be sure the latch is fully seated when closing your camera to ensure a

weather-tight seal.

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Pas de commentaire

Reconyx Hyperfire Manuel d'instructions Page 7